BiOrb Service Kit-Reef One
The BiOrb filter cartridge works like a waste bin, trapping dirt, once full it should be thrown away and replaced with a new one. This should be done every 1-2 months
A partial water change of 20% should be carried out at the same time.
Contents:
Reef One BiOrb Service Kit Replacement Filter Cartridge
Reef One BiOrb Service Kit...Algae Cleaning Cloth
Reef One BiOrb Service Kit...Water Conditioning Treatments
FOR THE BEST RESULTS FOLLOW THESE SIMPLE 8 STEPS.
Ideally perform steps 1 and 2, 24 hours before starting step 3.
The fresh water will need at least 1 hour to stabilize and reach room temperature.
STEP ONE
Wipe the inside of the biOrb to remove any algae growth that may have occurred.
Use the rough side for stubborn marks only.
Reef One BiOrb Service Kit
STEP TWO
Mix the chemical from the sachet of Water Treatment into 10 litres of tap water. Allow water to stabilize for at least 1 hour, preferably 24 hours.
Reef One BiOrb Service Kit
STEP THREE
Turn off air pump. Gently twist in direction of arrow and lift away filter from fixed base unit of biOrb.
Reef One BiOrb Service Kit
STEP FOUR
Siphon 1/3rd of the water from the biOrb. Agitating the rocks will help loosen any trapped dirt. Place siphon tube into filter recess and suck through the holes. Removing the solid waste will help prevent nitrate and phosphate build up.
Reef One BiOrb Service Kit
STEP FIVE
Gently twist in direction of arrow and lift away bubble tube from old filter cartridge.
STEP SIX
Offer up new BiOrb filter cartridge to bubble tube and twist in direction of arrow ensuring all four cartridge tabs are fully locked.
STEP SEVEN
Making sure there are no fish in the way, secure new filter cartridge back into base unit.
Reef One BiOrb Service Kit
STEP EIGHT
Slowly top up with the water prepared in step 2. Turn on air pump. Allow water to stabilize for 1 hour then add chemicals from Stress Zyme sachet.
Reef One BiOrb Service Kit
